Niteparts

Niteparts Original Parts

 

1JZ/2JZ-W55 Bell-Housing

Niteparts alloy JZ-W bellhousing. Suits use of W55/56/57/58 Supra or G52 Hiace/Hilux gearboxes behind 1JZ-GE, 1JZ-GTE, 2JZ-GE & 2JZ-GTE series engines.
Uses factory W55 fork, pivot, release bearing & slave cylinder.

For queries please contact Brendan on brendan@niteparts.co.nz.

1JW55Bell

 

4AGE-W55 Bell-Housing

The original Niteparts alloy A-W bellhousing. Suits use of W55/56/57/58 or G52 gearboxes behind 3A, 4A, 5A & 7A series engines.
Uses factory W55 fork, pivot & bearing. T-50 or W55 slave cylinders can be used.Factory 4AGE starter is used or high torque 1G starter with one of our adaptor plate kits.
Allows use of larger 225mm & 230mm 4AGZE clutch & flywheel setups. (Some aftermarket clutch covers may require some clearancing).

For queries please contact Brendan on brendan@niteparts.co.nz.

4AGEW55Bell

 

W55/G/R Release Bearing Carrier- ‘SHORT’

New CNC steel release bearing carrier to suit W55/56/57/58, G52, R150/151(4WD) gearboxes.
Allows use of fullface bearing (shown fitted but not included in auction) available from any repco, etc ($25-30)
Also gives extra height to suit conversions such as 4AGE-W55, 1UZFE-W or R where people may be using lower profile FWD clutch covers.
Extra ‘tail’ length to prevent falling off the end of gearbox snout.
Most retainer clips from your old bearing with fit too as shown in 2nd photo with fork)

If your bearing doesnt have quite enough reach, slips inside the clutch cover fingers or you dont have an original toyota cast carrier- you need this.

New release bearing to suit (as shown) also available.

For queries please contact Brendan on brendan@niteparts.co.nz.

W55ReleaseShort

W55ReleaseShort2

 

R154 Release Bearing Carrier- ‘LONG’

New CNC steel release bearing carrier (LONG) to suit R154 2wd gearboxes.
Allows use of fullface bearing (shown fitted but not included in auction) available from any repco, etc (GSB342-$25-30)
Also gives extra height to suit conversions using R154 Supra gearboxes where people may be using lower profile FWD clutch covers.
Extra ‘tail’ length to prevent falling off the end of gearbox snout.
Most retainer clips from your old bearing with fit too (as shown in 2nd photo with fork)

If your bearing doesnt have quite enough reach, slips inside the clutch cover fingers or you dont have an original toyota cast carrier- you need this.

New release bearing to suit (as shown) also available.

For queries please contact Brendan on brendan@niteparts.co.nz.

R154ReleaseLong

W55ReleaseShort2